This feature is created to minimize time inputting same defendant addresses on each and every new job cases. It's not default though, so it needs to be configured in the holder details area to enable or disable it.

Steps on how to configure:
1.) In the menu bar, go to Config->General Setup->Holders and Office Staff
2.) Click on your holder name
3.) Check/Uncheck the checkbox "Auto Populate Addr On Def" to Enable/Disable


When it's been enabled/disabled, it should be automatically being applied to your new job screen:
 - In the below enabled example, upon typing "test new defendant x", there are two results...by clicking one from the list...aside from defendant name, it will also auto populate the previously saved/entered record of that defendant address...such as Addr, Addr1, State, County, and Zipcode

Figure 1.


Figure 2.



- In the below disabled example, upon typing "test new defendant x", there's only one result...and by clicking that defendant name, it will just auto populate the Defendant name only

Figure 3.